MANDO DE FOCO TILTA NUCLEUS-M

Each motor has its own built-in radio unit that communicates directly with the handheld unit. This negates the need to mount a separate wireless receiver on your rig, allowing for a more compact camera setup and faster setup time. Simply set the motors and drive to the same channel and you have full control. The motors allow for automatic lens calibration, as well as manual calibration if you are using lenses that do not have hard end stops at close focus and infinity. Motors are designed to attach to 19mm or 15mm rods (with reducers included). This clamping design allows you to easily connect and disconnect motors without needing to remove any other accessories from your setup. Each motor has a 0.8 gear, 32 pitch gear, which is the standard gear size for cine lenses. To power the motors, you only need to use one power port on your camera equipment. Simply connect the d-tap power cable to one of the motors and then daisy chain the rest of the motors with the short 7 to 7 pin cables.